#What is plunge rate vectric vcarve pro how to#

These often provide a good starting point but can usually be further improved through a small amount of trial and error. There are many resources available to help determine suitable settings for particular material / router bit combinations.

#What is plunge rate vectric vcarve pro how to#

How to calculate the right parametersДЇeeds and speeds are usually all set in the programming software that is used to create the machine program. Similarly, if you cut at too low a feed rate or with too high a spindle rpm there is a risk of overheating the router bit and potentially burning or melting the workpiece. Sometimes it is possible to cut at a faster feed rate by increasing the spindle rpm.

Feed rate and spindle speed are inter-related. The Spindle speed in rpm should be set to a value that is appropriate for the tool being used and the material being processed. It is important not to plunge too fast as it is easy to damage the tip of the cutter during this operation. Plunge rate is the speed at which the router bit is driven down into the material when starting a cut and will vary depending on the bit used and the material being processed. This is normally set to as high a level as possible in order to reduce cycle times. Slew rate is the speed that the machine moves when above the material and is travelling between cuts. The feed rate represents how fast the machine will move the router bit though the material when cutting and is critical to get right for leaving a good quality cut edge.

вЂFeeds and speedsвЂ™ is generally used to refer to вЂfeed rateвЂ™, вЂslew rateвЂ™, вЂplunge rateвЂ™ and вЂspindle rpmвЂ™. There are certain parameters that must be considered, before setting up any job for processing if you are to achieve the finish and accuracy required.В This blog discusses the importance of choosing the right speeds and feeds for your application, the doвЂ™s and donвЂ™ts and how to calculate the right parameters.